When a Message Appears to Replace Consumables or Carry Out Cleaning
When staples in the Finisher have run out
When staples in the Finisher have run out, the following message appear.
Take action while referring to the label inside the machine.
For details on the replacement procedure when using the Finisher FS-535, refer to Here (only for bizhub C554e).
For details on the replacement procedure when using the Saddle Stitcher SD-512, refer to Here (only for bizhub C554e).
For details on the replacement procedure when using the Finisher FS-534, refer to Here.
For details on the replacement procedure when using the Saddle Stitcher SD-511, refer to Here.
For details on the replacement procedure when using the Finisher FS-533, refer to Here.
When the punch scrap box is full
When the punch scrap box is full, the following message appears (at replacement by user).
Take action while referring to the label inside the machine.
For details on the handling procedure when using the Finisher FS-535, refer to Here (only for bizhub C554e).
For details on the handling procedure when using the Z Folding Unit ZU-606, refer to Here (only for bizhub C554e).
For details on the handling procedure when using the Finisher FS-534, refer to Here.
For details on the handling procedure when using the Finisher FS-533, refer to Here.
When toner is running out in the Toner Cartridge
When toner is running out in Toner Cartridge, a message appears as shown below (at replacement by user).
When the Drum Unit needs to be replaced
When the replacement time has come for the Drum Unit, the following message appears (at replacement by user). Tap [Start Guidance], then follow the displayed guidance to take an action.
By the factory default status, this message is displayed only in some area.
The settings by the service representative are required to display a message about Drum Unit. For details, contact your service representative.
When the Developing Unit needs to be replaced
When the replacement time has come for the Developing Unit, the following message appears. If the message appears, contact your service representative.
By the factory default status, this message is displayed only in some area.
The settings by the service representative are required to display a message about Developing Unit. For details, contact your service representative.
When the Waste Toner Box is full
When the Waste Toner Box is full, the following message appears (at replacement by user). Tap [Start Guidance], then follow the displayed guidance to take an action.
